My smartphone does not connect to the "HeaterSetup" Wi-Fi network
During setup the panel heater will create its own Wi-Fi network. Your phone connects to this network during setup to send your home Wi-Fi network connection information to your panel heater.
In some cases your phone might not automatically connect to the panel heater during setup.
The HomeWizard Climate App uses iOS' automatic Wi-Fi connect feature. In some rare cases this feature may not work and will show errors such as 'already associated', 'system error', etc. When this happens, please reboot your iPhone and try again.
If this does not work, remove on you're iPhone the 'HeaterSetup' Wi-Fi seatings.
Forget a network on your iPhone.
- Go to'Settings'
- And than select 'Wifi'
- Tap next to the Wi-Fi network 'HeaterSetup.
- Tap 'Forget This Network'
- Then tap 'Forget' to confirm.
- Reboot your iPhone after doing this and try the setup again.
you may have to put your Heater in setup mode again to make the Wi-Fi network visible in your iPhone's Wi-Fi settings. To do so, turn on the Heater and long-press the 'ON' icon until you hear 3 beeps.
The automatic Wi-Fi connection to the panel heater may not work depending on the type of telephone. If this happens, do the following:
- Put the Panel heater in pairing mode
- Switch on the Panel heater and keep the 'ON/OFF' pressed until you hear 3 beeps
- Open the 'HomeWizard Climate ' -app on your phone and make sure your phone is connected to your home network or 4G (the phone must have an active internet connection)
- Tap 'Settings' at the top right of the screen
- Then tap 'My climate device'
- Tap 'Add new device'
- Tap on'Panal heater'. The installation procedure is started.
- Tap on 'Start setup' in the 'Make sure the panal is on' screen
- Tap 'Next' in the 'Why we need your location' screen and give the 'HomeWizard Climate' app permission to use your location
- This permission is only required during installation and can be withdrawn after you have installed your device.
- Tap 'Next' in the 'Start pairing mode' screen (you have already put the device in pairing mode)
- While the App is searching for devices, go to your Android Wi-Fi settings (you leave the HomeWizard Climate App)
- In your Android Wi-Fi settings you connect to:
Wi-Fi netwerkname: 'HeaterSetup'
- When you are connected to 'HeaterSetup' you return to the 'HomeWizard Climate' -app and follow the rest of the installation steps.
Need more help
Did you go through all of the steps mentioned above and you still could not add your Heater; Then contact our technical support.